Door Reversibility - Zanussi ZRA25100WA User Manual

Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply. The appliance
must be earthed. The power supply cable plug
is provided with a contact for this purpose. If the
domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
qualified electrician.
The manufacturer declines all responsibility if the
above safety precautions are not observed. This
appliance complies with the E.E.C. Directives.
Installation
Important
In order to reserve the required space around
the appliance for ventilation,please keep 100mm
distance between 2 sides and top of the freezer
appliance and the wall and 50 mm distance
between rear of appliance and the wall.
www.zanussi.com
ZRA25100WA_1602.indb 21
Levelling
The appliance should be level in order to
eliminate vibration. To make the appliance level,
it should be upright and both adjusters should
be firmly in contact with the floor. You can also
adjust the level by screwing out the appropriate
level adjuster at the front (use your fingers or a
suitable spanner).

Door reversibility

The side at which the door opens can be
changed from the right side (as supplied) to the
left side, if the installation site requires To begin
lay the appliance on its back in order to gain ac-
cess to the base, you should rest it on soft foam
packaging or similar material to avoid damaging
the cooling pipes at the rear of the appliance.
1. Remove 2 screws from the rear and lift the
back part of the top cover, then pull off the
whole cover toward the front of appliance.
2. Remove the three flange screws, then
remove the top hinge. Lift the door and place
it on a padded surface to prevent scratching
it.
21
EN
2016-02-25 08:24:05