What To Do If - Zanussi ZRA25100WA User Manual

What to do if...

Caution!
Before troubleshooting, disconnect the
power supply.
Only a qualified electrician or competent person
must do the troubleshooting that is not in this
manual.
Problem
Temperature regulation knob is set
at number "0".
Mains plug is not plugged in or is
Appliance
loose.
does not work.
Fuse has blown or is defective.
Socket is defective.
Appliance
Temperature is set too cold.
cools too much
Temperature is not properly adjust-
ed.
Door was open for an extended
period.
The food is not
A large quantity of warm food was
frozen enough.
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
Water on the
Water drain hole is blocked.
floor
Appliance is not level.
The appliance is touching the wall
or other objects.
Unusual
noises. A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
If the malfunction shows again, contact the
Service Centre.
These data are necessary to help you quickly
and correctly. Write the necessary data here,
refer to the rating plate.
www.zanussi.com
ZRA25100WA_1602.indb 19
Important! There are some sounds during
normal use (compressor, refrigerant circulation).
Possible cause
Model description
(Mod.)
Product number
(PNC)
Serial number
(S.N.)
Solution
Set the knob at another number to switch
on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by
an electrician.
Turn the temperature regulation knob to a
warmer setting temporarily.
Please look in the initial Control Panel
section.
Open the door only as long as necessary.
Turn the temperature regulation to a cold-
er setting temporarily.
Please look in the installation location
section.
See the Cleaning and Care section.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the compo-
nent out of the way.
19
EN
2016-02-25 08:24:05