SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. •...
• Do not put electrical appliances (e.g. ice cream • Before maintenance, deactivate the appliance makers) in the appliance unless they are stated and disconnect the mains plug from the mains applicable by the manufacturer. socket. • Be careful not to cause damage to the •...
CAUTION! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
1. Disconnect the appliance from electricity supply. 2. Remove all food. 3. Clean the appliance and all accessories. 4. Leave the door/doors open to prevent unpleasant smells. PERIODS OF NON-OPERATION When the appliance is not in use for long periods, take the following precautions: TROUBLESHOOTING WARNING! Refer to Safety chapters.
Problem Possible cause Solution Many food products were Store less food products at the stored at the same time. same time. There is too much condensed Door was opened too fre- Open the door only when neces- water on the rear wall of the quently.
ELECTRICAL CONNECTION • This appliance complies with the E.E.C. Directives. • Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond INSTALLATION OF THE APPLIANCE AND to your domestic power supply. DOOR REVERSAL • The appliance must be earthed. The power supply cable plug is provided with a contact for Please refer to separate instructions this purpose.