Diodes AP3041EV1 User Manual

General Description

This demonstration board utilizes the
AP3041 high voltage low-side N-channel
MOSFET controller
regulators. It contains all the features
needed to implement single-ended primary
topology DC/DC converters. The input
voltage of AP3041 ranges from 5V to 27V.
Its operation frequency is adjustable from
100kHz to 1MHz.
The AP3041 has UVLO (Under Voltage Lock
Out) circuit. It uses two external resistors to
set the UVLO voltage. The AP3041 also has
an over output voltage protection to limit
the output voltage. The OVP voltage can be
set through external resistors. If the output
voltage is higher than the OVP high
threshold point, it will disable the driver
and the system is latched up. The output
short circuit protection as well as LED low
side short to ground detection function can
be applied in system.
The AP3041 has other protection functions,
such as LED short protection, LED high side
short to ground protection, diode short
protection, over current protection, over
temperature protection and so on.

Applications

• LED Lighting
• LED TV
• LCD Display Modules
AP3041EV1
May 2014
www.diodes.com
ideal for boost
AP3041EV1 User Guide

Key Features


Input Voltage Range: 5V to 27V

1A Peak and 10V MOSFET Gate Driver

20ns Quick MOSFET Gate Driver

Duty Cycle Limit of 90%

Programmable UVLO

PWM Dimming Control

Programmable Over Voltage Protection

LED Open Protection

LED Short Circuit Protection

Diode Short Circuit Protection

Output Short Circuit Protection

LED Low-side Short to Ground
Detection

OV Pin Under Voltage Protection

Over Current Protection

Programmable Slope Compensation

Adjustable Soft-start

Adjustable Protection Delay

Fault Status Indication

Adjustable Operation Frequency from
100kHz to 1MHz

Over Temperature Protection

AP3041EV1 Specifications

Parameter
Input Voltage
LED Current
Number of LEDs
XYZ Dimension
Value
IC 12V
DC
System 100V
DC
125mA
60 LEDs in series
(Vo=195V)
80mm x 65mm x 18mm
Page 1 of 7