3-11. SLED MOTOR ASSY
2 three serration screws
(M2
3)
3 sled motor assy
turn table
stand
–
stand
Note 1: Place the stand with care not to touch the turn table.
–
CDX-GT660UE/GT660UP/GT660UV/GT662UE/GT710UV/GT717UV
1 spring
spring
Note 2: Never remove these parts since they were adjusted.
–
bearing (R)
–
three serration screws
(M2
3)
sled motor assy
Note 3: Take care to prevent the chassis from being bent
when tightening the three machine screws.
–
CDX-GT660UE/GT660UP/GT660UV/GT662UE/GT710UV/GT717UV
3-12. OPTICAL PICK-UP SECTION
bearing (F)
–
3-13. OPTICAL PICK-UP
2 leaf spring (sub guide)
5 optical pick-up
Notes for Assembly
Prevent the end of the
leaf spring (sub guide) from being
in contact with the OP slide base.
15
15
2 optical pick-up section
1
Note: Be careful not to touch the lens and hologram
terminal when removing the optical pick-up section.
–
bottom side view
–
1 pan tapping screw
(M1.4
2.5)
3 leaf spring (OP)
–
bottom side view
–
Prevent the end of the
leaf spring (sub guide) from being
in contact with the OP slide base.
4 lead screw assy
There is space at the end of the
leaf spring (sub guide) to avoid
contact with the slide.