Front Panel Component Function SDI Input Port From your SDI Device plug into this port SDI Pass Thru From your SDI Display Device plug into this ports Ref In Port From your Ref Sync Device plug into this port L/R audio input port From your L/R audio Device plug into this port USB Port Upgrade firmware/Control Box From PC...
DipSwitch/LED Control Component Function Control Mode Control Box from Dipswitch or USB Input Source Select Input Source( HDMI/SDI ) Genlock mode Select Genlock Mode(Free/Genlock) Audio Source Select Audio Source 4K Enable Select 4K or FHD format Output format Select output format ...
Page 6
Genlock mode: Select Genlock mode Genlock mode Dipswitch Indicates Free Run Genlock Input Audio mode: Select Audio Source, five kinds of mode can be select Input Source Dipswitch Indicates Default HDMI External L/R Audio...
Installation SDI2HD-DS4K installation consists of the following: 1. Disconnect +12DC adaptor to converter. 2. Connect Video Source to the Input Connector. 3. Connect Display Equipment to the output’s connector 4. Connect the +12DC adaptor to the converter. Package Contents SDI2HD-DSpackage contains the following items:...
Specifications DESCRIPTION SDI Format SD-SDI, HD-SDI & 3G-SDI SDI Transition Rate 2.970Gb/s, 1.485Gb/s and 270Mb/s HDMI Format VESA, CEA-861 Audio Support 8 - Channel Coaxial Cable Type RG6/RG59(75Ω) 3G: 100m of RG6/ 86m of RG59 HD: 170m of RG6/ 120m of RG59 SD: 400m of RG6/ 280m of RG59 Cable Equalization...
Firmware Upload Firmware is upgradable in the field using the integrated USB port How to Firmware upgrade: Step 1. Open Upload Firmware Program tools.exe and connect box to PC by USB Cable. Step 2. Plug and un-plug “DC adapter” to power on/off the converter box (the connection check status will be changed to “Connect”)
Page 11
Step 3. Plug and un-plug “DC adapter” again (the connection check status will be changed to “Connected”) and Please click the Open File button to select the firmware bin file. Step 4. Please click “Start’ Button to proceed with new firmware programming. The PASS message will appear when the procedures finished.