Setting The Bluetooth Standby Mode; Turning On Or Off The Bluetooth Signal - Sony GTK-XB60 Operating Instructions Manual

Hide thumbs Also See for GTK-XB60:
Table of Contents

Advertisement

Available languages

Available languages

LDAC is an audio coding
technology developed by Sony,
that enables the transmission
of High-Resolution (Hi-Res)
Audio content, even over a
BLUETOOTH connection. Unlike
other BLUETOOTH compatible
coding technologies, such as
SBC, it operates without any
down-conversion of the Hi-Res
Audio content
. It also allows
1)
approximately three times more
data
than the other technologies,
2)
for transmitting over a
BLUETOOTH wireless network with
unprecedented sound quality using
efficient coding and optimized data
bundling.
Excluding DSD format contents.
1)
In comparison with SBC (Sub Band
2)
Codec), when the bit rate of 990 kbps
(96/48 kHz) or 909 kbps (88.2/44.1 kHz)
is selected.
Setting the BLUETOOTH
standby mode
The BLUETOOTH standby mode
enables the system to turn on
automatically when you establish
the BLUETOOTH connection with a
BLUETOOTH device. This setting is
turned off by default.
This setting can only be configured by
using "Sony | Music Center." For details
on "Sony | Music Center," see "Using
"Sony | Music Center" and "Fiestable"
via BLUETOOTH connection"
(page 20).
Note
The BLUETOOTH standby mode can only
be set to on while the AC power cord is
connected.
Hint
Disable the BLUETOOTH standby mode to
reduce the power consumption in standby
mode (eco mode).
Turning on or off the
BLUETOOTH signal
You can connect to the system
from a paired BLUETOOTH device
in all functions when the system's
BLUETOOTH signal is set to on. This
setting is turned on by default.
Hold down STAMINA
and W.PARTY CHAIN
more than 5 seconds to turn off
the BLUETOOTH signal.
AUDIO IN indicator will flash once.
Notes
• You cannot perform the following
operations when you turn off the
BLUETOOTH signal:
— Pairing and/or connecting with
BLUETOOTH device
— Using "Sony | Music Center" via
BLUETOOTH connection
• To turn on the BLUETOOTH signal, repeat
the procedure shown above. When the
BLUETOOTH signal turns on, the AUDIO IN
indicator flashes 3 times.
BATTERY
LIGHT for
19
GB

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gtk-xb90

Table of Contents