Enjoying Music With The Speaker Lights - Sony GTK-XB60 Operating Instructions Manual

Playing music with two systems
1
Activate the pairing mode on
system , and then perform
the BLUETOOTH connection
with a BLUETOOTH device.
For details on the pairing, see
"Pairing this system with a
BLUETOOTH device" (page 13)
or "One Touch BLUETOOTH
Connection by NFC" (page 15).
Make sure to pair the BLUETOOTH
device with system  (master
system).
2
Start playback on the
BLUETOOTH device, and
adjust the volume.
For details, see "Listening to
music on a BLUETOOTH device"
(page 16).
Volume adjustments made on
either one of the systems are also
reflected on the other system.
Notes
• If any other BLUETOOTH device(s), such
as a BLUETOOTH mouse or BLUETOOTH
keyboard, is connected to the BLUETOOTH
device that is connecting with the system,
there may be distorted sound or noise in
the system output. In this case, terminate
the BLUETOOTH connection between the
BLUETOOTH device and other BLUETOOTH
device(s).
• If you reset one of the two systems while
using the speaker add function, make
sure to turn off the other system. If you
do not turn off the other system before
restarting the speaker add function, there
may be problems in making a BLUETOOTH
connection and outputting sound.
To deactivate the speaker add
function
Press ADD. The ADD L/R indicators will
be turned off.
Hint
Unless you deactivate the function, the
system will try to establish the last made
connection next time you turn on the
system.
28
GB
Enjoying music with the
Speaker Lights
The Speaker Lights are turned on by
default.
You can also select various light
modes such as the following by using
"Sony | Music Center" (page 20).
• RAVE: a light mode suitable for
dance music with a lot of flashing
• CHILL: a light mode suitable for
relaxing music
• RANDOM FLASH OFF: a light mode
without flash suitable for all music,
including dance music
• HOT: a light mode of warm color
• COOL: a light mode of cool color
• STROBE: a light mode with an
electronic flash of white color
To turn off the Speaker Lights
Hold down W.PARTY CHAIN
To turn on the Speaker Lights, hold
down W.PARTY CHAIN
Note
If the illumination brightness is glaring,
switch on the room lights or turn off the
illumination.
LIGHT.
LIGHT again.