Samsung NX58H5650WS Service Manual page 52

4. Troubleshooting
SYMPTOM
*
*
*
None of the
cooktop burners
*
will light.
*
*
*
*
One cooktop
burner does not
light.
*
*
*
*
All surface
burners will light,
but don't stay lit.
*
*
One cooktop
burner lights, but *
doesn't stay lit.
*
DIAGNOSIS
There is no electrical power to the
range.
The gas supply valve to the range is
closed.
Check the terminals on the spark
module for voltage.
Check for crimped or broken gas line
between the pressure gas regulator
and the surface burner control
manifold.
Gas pressure regulator switch is
closed.
Check the harness connections at
the spark module.
Check the spark module.
Check the electrode for that burner.
Check for a dirty surface burner
Check for crimped or broken gas
lines.
Faulty surface burner control
Check for crimped gas line between
the pressure gas regulator and the
surface burner control manifold.
Faulty gas pressure regulator.
Check for a dirty surface burner
Check for a crimped gas line.
Faulty surface burner control.
* Plug in the power cord and/or reset the
circuit breaker for the range.
* Open the gas supply valve.
* Replace the faulty spark module.
* Replace the damaged gas line.
* Replace the gas pressure regulator.
* Reconnect loose conection or replace
damaged harness.
* Disconnect the spark module terminal for
the nonworking burner. If no voltage is
measured, replace the spark module.
* Disconnect the electrode and check whether
electrode wire or tip is broken. Replace the
faulty electrode.
* Clean and/or replace the surface burner
NOTE:
always be the same size as removed.
* Replace damaged gas lines.
* Each surface burner control is an integral
part of the surface burner control manifold.
Replace the manifold.
* Replace the damaged gas line.
* Replace the gas pressure regulator.
* Clean and/or replace the surface burner
NOTE:
always be the same size as removed.
* Replace the crimped gas line.
* Each surface burner control is an integral
part of the surface burner control manifold.
Replace the manifold.
50
REMEDY