4. Troubleshooting
4-1 Failure Display Codes
Safety error
Failure code
E-0E
(Door lock in wrong position after
CAUSE
Door locking error
1 minute.)
39
SOLUTION
1. Disconnect electrical power to the range.
Remove the upper rear cover panel.
Make sure the wiring harness is properly
connected to the motorized door lock
assembly.
2. Check motorized door lock assembly for
proper operating resistances.
3. With operating door lockout, measure the
voltage of connector on harness which is
linked with door lock motor.
(Normal Voltage : AC 120V)
4. Check the door locking switch to make sure
it is working properly.