Uconnect 7.0 Owner's Manual Supplement page 42

While in Do Not Disturb, Conference Call can be selected
so you can still place a second call without being inter-
rupted by incoming calls.
NOTE:
• Reply with text message is not compatible with iPhones.
• Auto reply with text message is only available on
phones that supporting Bluetooth MAP.
Place/Retrieve A Call From Hold
During an active call, press the "Hold" button on the
Phone main screen.
Making A Second Call While Current Call Is In
Progress
You can place a call on hold by pressing the "Hold" button
on the Phone main screen, then dial a number from the
dialpad, recent calls, SMS Inbox or from the phonebooks.
To go back to the first call, refer to "Toggling Between
Calls" in this section. To combine two calls, refer to "Join
Calls" in this section.
Toggling Between Calls
If two calls are in progress (one active and one on hold),
press the "Swap" button on the Phone main screen. Only
one call can be placed on hold at a time.
You can also push the Phone
the active and held phone call.
Join Calls
When two calls are in progress (one active and one on
hold), press the "Join Calls" button on the Phone main
screen to combine all calls into a Conference Call.
Call Termination
To end a call in progress, momentarily press the Phone
"End" button on the touchscreen or the Phone "End"
button on the steering wheel. Only the active call(s) will
be terminated and if there is a call on hold, it will
become the new active call.
Redial
Press the "Redial" button on the touchscreen, or push the
Phone button and after the "Listening" prompt and
the following beep, say "Redial."
UCONNECT 7.0 41
button to toggle between
3