Aux Mode - Uconnect 7.0 Owner's Manual Supplement

Tracks
Press the "trks" button on the touchscreen to display a pop
up with the Song List. The currently playing song is
indicated by an arrow and lines above and below the song
title. When in the "trks" List screen you can rotate the
TUNE/SCROLL knob to highlight a track (indicated by the
line above and below the track name) and then push the
ENTER/BROWSE knob to start playing that track.
Pressing the "trks" button on the touchscreen while the
pop up is displayed will close the pop up.
Audio
Refer to Radio Mode for adjusting the audio settings.

AUX Mode

Overview
AUX (Auxiliary Mode) is entered by inserting an AUX
device using a cable with a 3.5 mm audio jack into the AUX
port or by pressing the AUX button on the left side of the
display.
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX Port.
If you insert an Auxiliary device with the ignition ON and
the radio ON, the unit will switch to AUX mode and begin
to play when you insert the device cable.
Controlling The Auxiliary Device
The control of the auxiliary device (e.g., selecting playlists,
play, fast forward, etc.) cannot be provided by the radio;
use the device controls instead. Adjust the volume with the
VOLUME/MUTE rotary knob, or with the volume of the
attached device.
NOTE: The vehicle radio unit is acting as the amplifier for
audio output from the Auxiliary device. Therefore if the
volume control on the Auxiliary device is set too low, there
will be insufficient audio signal for the radio unit to play
the music on the device.
Media Mode
Press the "Media" button on the touchscreen to select the
desired audio source: AUX.
Audio
Refer to Radio Mode for adjusting the audio settings.
UCONNECT 7.0 27
3