Starting The Engine; Starting A Cold Engine - Polaris 9919412 Owner's Manual For Maintenance And Safety

OPERATION

Starting the Engine

Starting a Cold Engine

WARNING
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
1. Place the transmission in PARK
and lock the parking brake.
2. Turn the fuel tank valve on.
3. Sit on the vehicle and pull the
choke knob (1) out until it stops.
NOTE: The variable choke is fully on
when the knob is pulled
completely out. The choke is off
when the knob is pushed
completely in. The choke can
be adjusted gradually, depending on how much choke is
needed for starting. Be sure the choke is off during
operation, as excess fuel washing into the engine oil will
increase wear on engine components.
4. Turn the engine stop switch to RUN.
NOTE: Do not press the throttle while starting the engine.
5. Turn the ignition key past the ON position to engage the starter.
Activate the starter for a maximum of five seconds, releasing the
key when the vehicle starts. If the engine does not start, release the
starter and wait five seconds. Activate the starter for another five
seconds if necessary. Repeat this procedure until the engine starts.
6. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm-up.
7. Vary the engine RPM slightly with the throttle to aid in warm-up.
When the engine idles smoothly, push the choke completely in.
CAUTION
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle.
50
1