Proscrub Operation - Aztec PROSCRUB Owner's Manual

PROSCRUB OPERATION

For your safety, to ensure compliance with environmental regulations, and to maximize the service life
of your equipment, it is very important to take a few minutes before you operate this machine to check
its condition. Be sure to take care of any problem you find, or have your service dealer correct it before
you operate this machine.
operation, may cause a malfunction in which you can be seriously hurt or killed. Always perform a pre-
operation inspection before each use, and correct any problem.
boxes. Avoid use in areas with loose debris or small objects that may become caught in the rotating
pad.
this machine. Follow the instructions given in this Owner's Manual and the training given by your
supervisor for the safe operation of this machine. Failure to do so can result in personal injury and/or
damage to the machine or property.
personnel. Do not operate, maintain, or service this autoscrubber unless you are trained and authorized.
materials.
Refer to the GENERAL OPERATION SAFETY Information on pgs 3-5 and the BEFORE OPERATION
CHECKLIST on pg 6 before operating the ProScrub:
1. Lower squeegee by releasing the Squeegee Lift Lever and lowering it from the "locked" position.
2. Push top of Foot Pedal Lever forward to release the pad drive/brush drive down.
3. Turn Vacuum Motor Switch to ON position.
4. Turn Solution Control Knob counter clockwise slightly to activate flow. The more the lever is
turned, the faster the flow of solution. Open completely for maximum flow.
5. Turn Brush Motor switch to "ON" position. Do not let the scrubber stay in one position for more
than a few seconds after brush rotation has started; damage to floor may result.
08-2017
Improperly maintaining this machine, or failure to correct a problem before
Avoid use in areas with floor obstruction such as thresholds and floor outlet
READ and UNDERSTAND all instructions and safety messages before operating
The ProScrub autoscrubber should only be operated by fully qualified maintenance
This machine is not suitable for use around hazardous dust or other hazardous
Do not use this machine on surfaces with a gradient exceeding 2%.
PROSCRUB OWNER'S MANUAL PAGE 9