Battery Maintenance Schedule & Battery Charging - Aztec PROSCRUB Owner's Manual

BATTERY MAINTENANCE
disconnected and unplugged from wall outlet to avoid shock.
1.) To dissolve battery corrosion, mix a solution of baking soda and water. Brush solution carefully
over battery. Do not allow solution to enter battery cells.
2.) After drying, use a wire brush to clean terminal posts and cable connections.
3.) After all wires are connected, thoroughly apply a coating of grease to battery terminals to help
maintain a good connection and prevent further corrosion.
4.) Check for worn or loose cables and replace if necessary.
5.) Check fluid level in batteries every 10 charges (lead acid batteries only).
BATTERY CHARGING
sparks around the batteries.
Electric shock may occur.
working with lead acid batteries.
contact with the batteries or the electrical system of the autoscrubber. Damage will occur.
protection and face shield.
08-2017
Before any battery maintenance is done, make sure batteries and charger are
Keep battery terminals and surface clean and dry.
Battery lead acid may emit explosive gases. Never smoke or use flame or
Always unplug power-cord or disconnect batteries before servicing machine.
Battery acid can cause burns. Wear protective gloves and eye wear when
Do not store batteries outside or let water, chemicals, or any liquid come into
Always charge batteries in a well ventilated area, keep hood open, wear eye
PROSCRUB OWNER'S MANUAL PAGE 14