Throttle Cable; Coupler Greasing - Polaris 340 Touring Owner's Manual

MAINTENANCE
Lubrication
Jackshaft Bearing
Loosen the driven clutch retaining
bolt and pull the clutch outward to
expose the bearing and grease fit-
ting. Inject grease into the grease
fitting in the flangette until grease
purges from inside or outside the
bearing seal (may take only two
pumps). Push the clutch back onto
the shaft and replace the clutch
retaining bolt. Torque to 18 ft. lbs.
(24.4 Nm).

Coupler Greasing

(WideTrak)
Jackshaft
Grease the couplers on the
driveshaft and jackshaft.
Driveshaft

Throttle Cable

Lubricate the throttle cable lightly
with grease or oil. With the engine
off, turn the handlebars to the left
and lubricate liberally as shown.
Choke and Choke Cable
Lubricate the choke slide and cables
lightly with oil or grease. Before
turning the engine off, operate the
choke intermittently to draw mois-
ture out of the choke plunger area
and reduce the possibility of the
choke becoming frozen.
82