White Telltale Lights; Blue Telltale Lights; Onboard Diagnostic System - Obd Ii - Jeep COMPASS 2017 User Manual

— Cruise Control Set Indicator Light
— If Equipped
This light will turn on when the Speed Control
is SET. Refer to "Speed Control — If
Equipped" in "Starting And Operating" for
further information.
— LaneSense Indicator Light — If
Equipped
The LaneSense indicator is solid green when
both lane markings have been detected and
the system is "armed" to provide visual warn-
ings in the instrument cluster display and a
torque warning in the steering wheel if an
unintentional lane departure occurs. Refer to
"LaneSense — If Equipped" in "Starting And
Operating" for further information.

White Telltale Lights

— LaneSense Indicator Light — If
Equipped
When the LaneSense system is ON, the Lane-
Sense indicator is solid white when none or
only the left or right lane marking has been
detected. The indicator will turn green when
both lanes are detected and the system will
be ready to provide visual warnings in the
instrument cluster display if an unintentional
lane departure occurs. Refer to "LaneSense
— If Equipped" in "Starting And Operating"
for further information.
— Cruise Control Ready Indicator Light
This light will turn on when the cruise control
is ready, but not set.
— Speed Control SET Indicator Light
This light will turn on when the speed control
is set. Refer to "Speed Control — If
Equipped" in "Starting And Operating" for
further information.
— Active Speed Limiter ON Indicator
Light
This light will turn on when the Active Speed
Limiter is on, but not set.
— Hill Descent Control (HDC) Indicator
Light — If Equipped
This indicator shows when the Hill Descent
Control (HDC) feature is turned on. The lamp
will be on solid when HDC is armed. HDC can
only be armed when the transfer case is in the
"4WD LOW" position and the vehicle speed
is less then 30 mph (48 km/h). If these
conditions are not met while attempting to
use the HDC feature, the HDC indicator light
will flash on/off.

Blue Telltale Lights

— High Beam Indicator Light
This indicator shows that the high beam
headlights are on. Push the multifunction
control lever away from you to switch the
headlights to high beam. Pull the lever to-
ward you to switch the headlights back to low
beam. Pull the lever toward you for a tempo-
rary high beam on, "flash to pass" scenario.
ONBOARD DIAGNOSTIC
SYSTEM — OBD II
Your vehicle is equipped with a sophisticated
Onboard Diagnostic system called OBD II.
This system monitors the performance of the
emissions, engine, and automatic transmis-
sion control systems. When these systems are
73