Stopping The Cleaner And Removing From The Pool; Rinsing The Cleaner; Cleaning The Filter Canister - Zodiac TX20 Owner's Manual

Zodiac
3.3 Stopping the Cleaner
and Removing from the Pool
1. Press Start/Stop button to interrupt operation.
2. When the cleaner is within arm's reach, use the
handle to lift it from the water (Figure 5).
Never lift the cleaner out of the pool by the
floating cable.
Figure 5. Lift Cleaner From Pool with Handle
3. Hold the cleaner vertically over the pool surface
to drain water before removing (Figure 6).
Figure 6. Drain Water from the Cleaner
FX20 FX30 FX35 Robotic Pool Cleaner
®
|
ENGLISH
Owner's Manual
3.4

Rinsing the Cleaner

Rinse the cleaner after every cleaning cycle. Use
slightly soapy clean water, then rinse generously with
clean water. Do not use solvents such as trichlorethylene
or its equivalent. Do not let your cleaner dry in direct
sunlight near the pool.
3.5

Cleaning the Filter Canister

Empty the canister as soon as the cycle ends.
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.
1. Unplug power to the cleaner at the control unit.
Turn off power then unplug the control unit
from the power source.
2. Press the Push 'n' Go button to release the filter
canister handle (Figure 7).
Figure 7. Release Filter Canister Handle
Page 7