Charging By Connecting To A Computer - Sony Cyber-shot DSC-RX100M3 Instruction Manual

Charging time (Full charge)
The charging time is approximately 230 min. using the AC Adaptor (supplied).
The charging time may differ depending on the remaining capacity of the battery pack or the charging
conditions.
The battery pack can be charged even when it is not fully depleted.
The above charging time applies when charging a fully depleted battery pack (supplied) at a
temperature of 25°C (77°F). Charging may take longer depending on the conditions of use and the
environment.
To check the remaining battery charge, detach the micro USB cable and check the
charge indicator) on the screen.
Note
If the charge lamp flashes when the battery pack is not fully charged, remove the battery pack from
the camera and then re-insert it to recharge.
If the charge lamp on the camera flashes when the AC Adaptor is connected to the wall outlet (wall
socket), this indicates that charging is temporarily stopped because the temperature is outside the
recommended range. When the temperature gets back within the appropriate range, the charging
resumes. We recommend charging the battery pack at an ambient temperature of between 10°C to
30°C (50ºF to 86ºF).
Connect the AC Adaptor to the nearest wall outlet (wall socket). If malfunctions occur while using the
AC Adaptor, immediately disconnect the plug from the wall outlet (wall socket) to disconnect from the
power source.
When you use a completely new battery pack or a battery pack that has not been used for a long
time, the charge lamp may flash quickly when the battery is charged for the first time. If that happens,
remove the battery pack from the camera and then re-insert it to recharge.
Do not continuously or repeatedly charge the battery pack without using it if it is already fully charged
or close to fully charged. Doing so may cause a deterioration in battery performance.
When charging is finished, disconnect the AC Adaptor from the wall outlet (wall socket).
Be sure to use only genuine Sony brand battery packs, micro USB cables (supplied) and AC Adaptors
(supplied).
[9] How to Use

Charging by connecting to a computer

The battery pack can be charged by connecting the camera to a computer using a micro USB cable.
1. Turn off the product, and connect to the USB terminal of the computer.
Preparing the camera Charging the battery pack
(remaining