Jeep grand cherokee 2017 User Manual page 204

Front Fog Lamps
1. Reach through the cutout in the splash
shield and disconnect the wiring harness
from the fog lamp connector.
2. Firmly grasp the bulb by the two latches
and squeeze them together to unlock the
bulb from the back of the front fog lamp
housing.
3. Pull the bulb straight out from the keyed
opening in the housing.
CAUTION!
• Do not touch the new bulb with your
fingers. Oil contamination will severely
shorten bulb life. If the bulb comes in
contact with any oily surface, clean the
bulb with rubbing alcohol.
• Always use the correct bulb size and type
for replacement. An incorrect bulb size
or type may overheat and cause damage
to the lamp, the socket or the lamp
wiring.
202
4. Align the index tabs of the front fog lamp
bulb with the slots in the collar of the bulb
opening on the back of the front fog lamp
housing.
5. Insert the bulb into the housing until the
index tabs are engaged in the slots of the
collar.
6. Firmly and evenly push the bulb straight
into the lamp housing until both tabs snap
firmly into place and are fully engaged.
7. Connect the wiring harness to the front
fog lamp connector.
Rear Tail, Stop, and Turn Signal Lamps
1. Raise the liftgate.
2. Remove the two push-pins from the tail
lamp housing.
Tail Lamp Push Pins
3. Grasp the tail lamp and pull firmly rear-
ward to disengage the lamp from the ap-
erture panel.
4. Twist socket counter clockwise and re-
move from lamp.