Table of Contents
Advertisement
NX-CDR7R
Removing the front panel assembly
Prior to performing the following procedure, remove
the metal cover.
1.
Disconnect the card wire from connector CN705,
CN708, CN704 and CN712 on the main board.
2.
Disconnect the wire from connector CN905 on the
power board.
3.
Remove the two screws C on each side of the body.
4.
Remove the two screws D
body.
5.
Disengage the joint a on the bottom and the two
joints b on the lower side of the body using a
screwdriver. Then remove the front panel assembly
toward the front.
1-6
(See Fig.3 to 6)
on the bottom of the
D
Front panel assembly
Joint a
Fig.6
Front panel assembly
CN704
Fig.3
Front panel assembly
Joint b
Fig.4
Main board
CN708
C
Fig.5
CN712
CN705
CN708
Main board
Power board
Main board
CN905
C
CN705
Front panel assembly
Joint b
Advertisement
Table of Contents
