Table of Contents
Advertisement
NX-CDR7R
Removing the CDR mechanism cover /
CDR mechanism assembly
Prior to performing the following procedure, remove
the metal cover, the front panel assembly, the rear
panel, the main board and the tuner board.
REFERENCE:
When removing the CDR mechanism
assembly only, refer to the next section.
REFERENCE:
When removing the fan only, refer to
"Removing the fan".
1.
Remove the spacer settling the card wire on the right
side of the body and release the wire from the clamp
and the notch i of the power board on the upper side
of the body. Disconnect the card wire from connector
CN702 and CN703 on the CDR connection board.
2.
Disconnect the wire from connector CN507 on the
CD servo board.
3.
Disconnect the wire from connector CN210 on the
power board on the back of the body and release the
wire from the notch h of the power amplifier board 2.
4.
Remove the four screws N on the upper front side of
the body and remove the CDR mechanism cover
toward the front. The CDR mechanism assembly and
the fan are also removed with the CDR mechanism
cover.
1-12
(See Fig.22 to 27)
Clamp
CDR mechanism cover
CDR connection board
CN703
Fig.22
N
Fig.23
Power amplifier board 2
Fig.24
Notch i
CDR connection board
CN702
CD servo board
CN507
CDR mechanism cover
N
Clamp
Notch i
Notch h
Advertisement
Table of Contents
