Table of Contents
Advertisement
Important! Be aware of the polarity when you connect devices
to the NLC: Connect plus to plus and minus to minus or you
won't see the expected behavior from the connected devices.
Using a Connected Device (Weather Station)
Connecting an ET device on‐site gives you the most accurate adjustments
as the ET device will monitor the exact weather condition right where
irrigation will take place.
Important! If for some reason your weather stations fails and
does not provide any input for the NLC the controller will fall
back on historical ET data and use these instead. The same goes
in case of a power failure ‐ the controller will use the historical
data for the part of today that lies before the power failure, and
then use real‐time ET data from when it is powered up again.
Bottom line: you should always enter a set of historical ET data
even when running with a connected weather station.
Configuring ET Input
1 Before moving on, make sure you have connected the ET device.
2
Turn the dial to
22
NLC‐100SH Installation and troubleshooting
ADVANCED
Advertisement
Table of Contents
Troubleshooting
