Cisco Catalyst 3750-E Software Configuration Manual page 1064

Configuring Multi-VRF CE
Multi-VRF CE Configuration Example
Figure 40-7
Figure
to PE connections. The examples following the illustration show how to configure a switch as CE
Switch A, and the VRF configuration for customer switches D and F. Commands for configuring CE
Switch C and the other customer switches are not included but would be similar. The example also
includes commands for configuring traffic to Switch A for a Catalyst 6000 or Catalyst 6500 switch acting
as a PE router.
Figure 40-7
Global network
Configuring Switch A
On Switch A, enable routing and configure VRF.
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# ip routing
Switch(config)# ip vrf v11
Switch(config-vrf)# rd 800:1
Switch(config-vrf)# route-target export 800:1
Switch(config-vrf)# route-target import 800:1
Switch(config-vrf)# exit
Switch(config)# ip vrf v12
Switch(config-vrf)# rd 800:2
Switch(config-vrf)# route-target export 800:2
Switch(config-vrf)# route-target import 800:2
Switch(config-vrf)# exit
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
40-86
is a simplified example of the physical connections in a network similar to that in
40-6. OSPF is the protocol used in VPN1, VPN2, and the global network. BGP is used in the CE
Multi-VRF CE Configuration Example
VPN1
Switch D
208.0.0.0
Fast
Ethernet
8
Switch E
108.0.0.0
Fast
Ethernet
7
VPN2
Switch F
118.0.0.0
Fast
Ethernet
11
Switch G
168.0.0.0
Fast
Ethernet
3
Switch A Switch B
CE1 PE
Gigabit
Ethernet
1
CE = Customer-edge device
PE = Provider-edge device
End with CNTL/Z.
Chapter 40 Configuring IP Unicast Routing
Switch C
VPN1
Switch H
VPN2
Switch J
CE2
Global network
Switch K
OL-9775-08