Cisco Catalyst 3750-E Software Configuration Manual page 1075

Chapter 40 Configuring IP Unicast Routing
Command
Step 18
set metric bandwidth delay reliability
loading mtu
Step 19 set metric-type {type-1 | type-2}
Step 20
set metric-type internal
Step 21 set weight
Step 22
end
Step 23 show route-map
Step 24 copy running-config startup-config
To delete an entry, use the no route-map map tag global configuration command or the no match or no
set route-map configuration commands.
You can distribute routes from one routing domain into another and control route distribution.
Beginning in privileged EXEC mode, follow these steps to control route redistribution. Note that the
keywords are the same as defined in the previous procedure.
Command
Step 1 configure terminal
Step 2
router {bgp | rip | ospf | eigrp}
Step 3 redistribute protocol [process-id] {level-1 | level-1-2 |
level-2} [metric metric-value] [metric-type type-value]
[match internal | external type-value] [tag tag-value]
[route-map map-tag] [weight weight] [subnets]
Step 4
default-metric number
Step 5 default-metric bandwidth delay reliability loading mtu
Step 6
end
OL-9775-08
Purpose
Set the metric value to give the redistributed routes (for EIGRP only):
bandwidth—Metric value or IGRP bandwidth of the route in
•
kilobits per second in the range 0 to 4294967295
• delay—Route delay in tens of microseconds in the range 0 to
4294967295.
reliability—Likelihood of successful packet transmission expressed
•
as a number between 0 and 255, where 255 means 100 percent
reliability and 0 means no reliability.
loading— Effective bandwidth of the route expressed as a number
•
from 0 to 255 (255 is 100 percent loading).
mtu—Minimum maximum transmission unit (MTU) size of the
•
route in bytes in the range 0 to 4294967295.
Set the OSPF external metric type for redistributed routes.
Set the multi-exit discriminator (MED) value on prefixes advertised to
external BGP neighbor to match the IGP metric of the next hop.
Set the BGP weight for the routing table. The value can be from 1 to
65535.
Return to privileged EXEC mode.
Display all route maps configured or only the one specified to verify
configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter router configuration mode.
Redistribute routes from one routing protocol to
another routing protocol. If no route-maps are
specified, all routes are redistributed. If the keyword
route-map is specified with no map-tag, no routes are
distributed.
Cause the current routing protocol to use the same
metric value for all redistributed routes (BGP, RIP and
OSPF).
Cause the EIGRP routing protocol to use the same
metric value for all non-EIGRP redistributed routes.
Return to privileged EXEC mode.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
Configuring Protocol-Independent Features
40-97