Display Hinge - Dell Latitude 7380 Owner's Manual

Installing display assembly
1 Place the base of the computer on a plane surface of a table and position it closer to the edge of the table.
2 Install the display assembly to align it with the display hinge holders on the system.
3 Holding the display assembly, tighten the M2.5 x 4.0 screws to secure the display hinges on the system display assembly with the
system unit.
4 Affix the tapes to secure the eDP cable (display cable).
For touch-configuration system you will see touch display cable, secure it with tapes along with the eDP cable.
5 Connect the eDP cable to the connector on the system board.
NOTE: For touch-configuration system, connect the touch display cable to its connector on the system
board.
6 Install the eDP metal bracket on the eDP cable and tighten the M2.0 x 5.0 screws.
7 Route the WLAN and WWAN cables through the routing channels.
8 Install the:
a WLAN card
b WWAN card
c base cover
9 Follow the procedure in
Display hinge cap
Removing display hinge Cap
1 Follow the procedure in
2 Remove the:
After working inside your computer.
Before working inside your computer.
Removing and installing components 29