ABB ACS800 Hardware Manual page 80

72
Connect the AGPS board as follows:
• Remove the enclosure cover by undoing the fixing screws (1).
• Ground the bottom plate of the enclosure or via terminal X1:1 of the AGPS board.
• Connect the cable delivered with the kit between terminal block X2 of the AGPS
board (2) and drive terminal block X41.
• Connect a cable between connector X1 of the AGPS board (3) and the
115...230 V source.
• Fasten the enclosure cover back with screws.
115...230 V
Installation of AGPS board (Prevention of Unexpected Start, +Q950)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
3
1
2
X2