AEG DCK731110M User Manual page 26

26 www.aeg.com
During the catalytic cleaning the oven
lamp is on.
1. Set the Cata cleaning function (refer
to "Oven functions"). The display
shows "Cata" and the duration of the
cleaning procedure (1 hour).
You cannot set the Duration, but you
can use the End function to delay the
start of the cleaning procedure.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2. Touch a sensor field or open the
oven door to stop the acoustic
signal.
3. Clean the bottom of the appliance
with a soft and moist sponge.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
3. Close the door until it is at an angle
of approximately 45°.
A
A
45°
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
2
B
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
1