Pride Mobility raptor series Owner's Manual page 18

I I I . B AT T E R I E S A N D C H A R G I N G
How do I change a battery in my scooter?
MANDATORY! Battery posts, terminals, and related accessories contain lead and lead
compounds. Wear goggles and gloves when handling batteries and wash hands after
handling.
PROHIBITED! Always use two batteries of the exact same type, chemistry, and amp-hour
(Ah) capacity. Refer to the product specifications insert and in the manual supplied with
the battery charger for recommended type and capacities.
WARNING! Do not mix old and new batteries. Always replace both batteries at the same
time.
WARNING! Contact your Provider if you have any questions regarding the batteries in
your scooter.
WARNING! Do not replace the batteries while the scooter is occupied.
WARNING! The batteries on your scooter should only be serviced or replaced by an
authorized Pride Provider or a qualified technician.
PROHIBITED! Keep tools and other metal objects away from battery terminals. Contact
with tools can cause electrical shock.
You may need the following to change your batteries:
„ Metric/standard socket set and ratchet
„ Adjustable wrench
WARNING! Do not lift beyond your physical capability. Ask for assistance when necessary while
disassembling or assembling your scooter.
WARNING! Do not pull on electrical harness wires directly to detach them from the scooter. Always
grasp the connector itself when disconnecting the harness to prevent wire damage.
To change batteries in your scooter:
1. Flip the seat up to access the rear storage compartment. See II. "Your Scooter."
2. Remove the two bolts from the storage bin. Lift the storage bin out of the rear storage compartment.
See figure 10.
3. Disconnect the battery harness and tie-down strap.
4. Disconnect the black (-) and red (+) battery cables from the battery terminals of each battery.
5. Remove the old batteries.
6. Place the new batteries into the battery wells, beginning with the left battery. Insert the left battery
on the right side, and slide it into the left position. Then, insert the right battery. See figure 10.
7. Connect the red battery cable to the positive (+) battery terminal of each battery.
8. Connect the black battery cable to the negative (-) battery terminal of each battery.
9. Connect the battery harnesses and battery tie-down strap.
10. Reposition the terminal boots over the battery terminals.
18
Raptor