Batteries And Charging - Pride Mobility raptor series Owner's Manual

I I I . B AT T E R I E S A N D C H A R G I N G

BATTERIES AND CHARGING

Your scooter requires two long-lasting, 12-volt, deep-cycle batteries
free. They are recharged by an off-board charging system.
„ Charge your scooter's batteries for at least 8 to 14 hours prior to using it for the first time.
„ Keep the batteries fully charged to keep your scooter running smoothly.
READING YOUR BATTERY VOLTAGE
The battery condition meter on the tiller console
indicates the approximate strength of your batteries.
See figure 8. To ensure the highest accuracy, the
battery condition meter should be checked while
operating your scooter at full speed on a dry, level
surface. Please refer to the "Battery Condition Indicator"
section in II. "Your Scooter."
CHARGING YOUR BATTERIES
PROHIBITED! Removal of grounding prong can create electrical hazard. If necessary, properly install
an approved 3-pronged adapter to an electrical outlet having 2-pronged plug access.
PROHIBITED! Never use an extension cord to plug in your battery charger. Plug the charger directly
into a properly wired standard electrical outlet.
PROHIBITED! Do not allow unsupervised children to play near the scooter while the batteries are
charging. We recommend that you do not charge the batteries while the scooter is occupied.
MANDATORY! Read the battery charging instructions in this manual and in the manual supplied
with the battery charger before charging the batteries.
WARNING! Explosive gases may be generated while charging the batteries. Keep the scooter and
battery charger away from sources of ignition such as flames or sparks and provide adequate
ventilation when charging the batteries.
WARNING! You must recharge your scooter's batteries with the supplied off-board charger. Do not
use an automotive-type battery charger.
WARNING! Inspect the battery charger, wiring, and connectors for damage before each use. Contact
your authorized Pride Provider if damage is found.
WARNING! Do not attempt to open the battery charger case. If the battery charger does not appear
to be working correctly, contact your authorized Pride Provider.
WARNING! If the battery charger is equipped with cooling slots, then do not attempt to insert objects
through these slots.
WARNING! Be aware that the battery charger case may become hot during charging. Avoid skin
contact and do not place on surfaces that may be affected by heat.
WARNING! If your battery charger has not been tested and approved for outdoor use, then do
not expose it to adverse or extreme weather conditions. If the battery charger is exposed to
adverse or extreme weather conditions, then it must be allowed to adjust to the difference in
environmental conditions before use indoors. Refer to the manual supplied with the battery
charger for more information.
14
that are sealed and maintenance-
Figure 8. Battery Condition Meter
Raptor