Pride Mobility raptor series Owner's Manual page 10

Speed Indicator
The LCD Screen displays your current traveling speed. The Hi-Low setting determines the maximum
scooter speed. When set to Low, the speed will be half of the maximum speed at the Hi setting.
Battery Condition Indicator
When the key is turned to the "on" position, the LED indicator gives an approximate reading of battery
strength.
Odometer/Tripometer
When the key is turned to the "on" position, The LCD Screen will initially display the odometer, or total
distance traveled, before resetting to zero and displaying the tripometer.
NOTE: Speed indicator and odometer/tripometer may not reflect actual speed and distance
traveled.
Off-board Charger Port
The off-board charger power cord, when plugged into
the charger power cord receptacle and a standard
electrical outlet, charges the scooter's batteries. See
figure 3. The off-board charger port will be located
at the front of the rear shroud, below the seat. See
figure 4.
Charger Power Cord Receptacle
The 3-pin end of the charger power cord plugs into the
receptacle. There is a protective rubber flap that, when
pressed into place, fits over the receptacle to shield it
from dirt, debris, moisture, or damage.
Electrical System Fuses
Your scooter is equipped with a series of electrical
system fuses, which help protect the off-board
charging system, key switch, and lighting system from
receiving an overload of electrical current. These fuses
are located in a compartment within the rear shroud,
below the seat.
NOTE: Keep all electrical areas clean and free of
moisture and foreign material.
10
I I . Y O U R S C O O T E R
XLR
Figure 3. Off-board Battery Charger
IDENTIFICATION KEY
1. Off-board Charger Port
Figure 4. Off-board Charger Port
1
Raptor