Pride Mobility raptor series Owner's Manual page 11

Tiller Adjustment
See V. "Comfort Adjustments".
Key Switch
„ Insert the key into the key switch and turn it clockwise to power up (turn on) your scooter.
„ Turn the key counterclockwise to power down (turn off) your scooter.
WARNING! If the key is turned to the "off" position while your scooter is in motion, the electronic
brakes will engage and your scooter will come to an abrupt stop!
Mirror Positioning and Adjustment
For information on positioning and adjusting your mirror, see V. "Comfort Adjustments."
REAR COMPONENTS
The manual freewheel lever and motor/transaxle
assembly are located on your scooter as shown.
See figure 5. The main circuit breaker (reset button)
and batteries (not shown) are also located in the
rear component section of your scooter.
WARNING! Before placing your scooter
into or taking it out of freewheel mode,
remove the key from the key switch. Never
sit on a scooter when it is in freewheel
mode. Never put a scooter in freewheel
mode on any incline.
Manual Freewheel Lever
Whenever you need or want to push your scooter for
short distances, you can put it in freewheel mode.
1. Remove the key from the key switch.
2. Push forward on the manual freewheel lever to
disable the drive system and the brake system.
This will enable you to push the scooter.
3. Pull back on the manual freewheel lever to
reengage the drive and the brake systems, and
take your scooter out of freewheel mode.
WARNING! When your scooter is in freewheel mode, the braking system is disengaged.
Disengage the drive motors only on a level surface.
„
Ensure the key is removed from the key switch.
„
Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on a scooter
„
to do this.
After you have finished pushing your scooter, always return it to the drive mode to lock the
„
brakes.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward)
key is in the "on" position, the scooter will not run until the manual freewheel lever is pushed
backward and the key is turned to the "off" position, then back to the "on" position.
Raptor
I I . Y O U R S C O O T E R
IDENTIFICATION KEY
1. Key Lock
2. Anti-Tip Wheels
3. Motor/Transaxle Assembly
4. Manual Freewheel Lever
Figure 5. Rear Components
1
3 4
2
while the
11