Advertisement
RX-7012VSL
Removing the voltage select board
Prior to performing the following procedures, remove
the top cover and the rear panel.
1.
Cut off the tie band fixing the harness.
2.
Unsolder the six harnesses connected to the power
transformer.
Removing the power / fuse board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1.
Remove the screw O attaching the power / fuse
board.
2.
Unsolder the power cord and other harnesses
connected to the power / fuse board.
Removing the power transformer
Prior to performing the following procedures, remove
the top cover.
1.
Unsolder the two harnesses connected to the power
transformer.
2.
Disconnect the harness from connector CN251 and
unsolder the harnesses connected to FW201 on the
power transformer board.
3.
Remove the four screws N attaching the power
transformer.
1-6
(See Fig.13)
Solder
points
Tie band
Power cord
Solder
points
(See Fig.13 to 14)
Voltage selector
(See Fig.14)
Power cord
Solder points
Fig.13
Power
transformer
board
CN251
Power / fuse board
Fig.14
Power
transformer
Voltage
select
board
Solder
points
Power
supply
board
FW201
Solder
points
N
Power
transformer
N
O
Solder
points
Advertisement
