Starting And Ending - Denso Intelligent Tester II Operator's Manual

2 Basic Operations
2
Basic Operations

Starting and Ending

Starting
1.
Connect the Intelligent Tester II and vehicle side datalink connectors (DLC3) with the datalink cable.
Reference: Page 14 Connecting to the Vehicle (Chapter 1. Before Use/Connection)
2.
Turn the vehicle ignition switch ON.
NOTE
Communication with the vehicle computer (ECU) is not possible if the ignition switch is at OFF or ACC.
When the Intelligent Tester II is turned ON, always switch the ignition switch ON or start the engine.
When the Intelligent Tester II is used as measurement function (voltage measurement, oscilloscope), it will
work even if the ignition switch is at OFF or ACC.
If the Intelligent Tester II is connected to the vehicle's diagnostic connector (DLC3) by a datalink cable and
supplied with power via an AC/DC adapter or DC power cable for a cigarette lighter socket, the Intelligent
Tester II can be operated even with its power switch turned off.
3.
Press the Intelligent Tester II power switch to turn the power ON.
CAUTION
During startup, never switch the Intelligent Tester II power switch OFF until the onboard/offboard check
screen is displayed.
Email: sales@obd2express.co.uk Skype: obd2express.co.uk
- 21 -
T00043E