Connecting The Oscilloscope Cartridge - Denso Intelligent Tester II Operator's Manual

1 Before Use

Connecting the Oscilloscope Cartridge

If you purchased the optional cartridge with the built-in oscilloscope, it is necessary to replace the standard cartridge with
this cartridge.
Loosen the five screws securing the standard cartridge and remove the cartridge.
Replace the standard cartridge with the built-in oscilloscope cartridge, and secure it in place by tightening the five screws
to a torque of 0.5±0.1 Nm.
CAUTION
Always make sure the power to the Intelligent Tester II is OFF before replacing the cartridge.
When connecting the cartridge with the built-in to oscilloscope to the main unit, carefully check the
configuration of the connector and gently insert the cartridge straight in.
Inserting the cartridge at a slant can break the connector pins.
Be careful not to touch the connector section of the main unit or the cartridge with your hands.
Email: sales@obd2express.co.uk Skype: obd2express.co.uk
- 17 -
T00040E