Related Manuals for Winco W10000VE/A
Summary of Contents for Winco W10000VE/A
- Page 1 W10000VE/A GENERATOR INSTALLATION AND OPERATORS MANUAL WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831 www.wincogen.com...
-
Page 2: Table Of Contents
Should you experience a problem please follow the “Troubleshooting STARTING ELECTRIC MOTORS Tables” near the end of this manual. The warranty listed in the manual PREPARING THE UNIT describes what you can expect from WINCO should you need service UNPACKING assistance in the future. LUBRICATION... -
Page 3: Specifications
1. ELECTRICAL SHOCK - GENERATOR The output voltage present in this equipment can cause fatal electric shock. This equipment must be operated by a responsible person. Model W10000VE/A A. Do not allow anyone to operate the generator without proper Surge Watts 10,000 instruction. -
Page 4: Introduction
All service, including the installation or replacement of service parts, should be performed only by a qualified technician. W10000VE/A: 120 Volt and 240 Volt receptacles are provided for A. Use only factory approved repair parts. connection to various loads. The diagram below represents this 9,600 B. -
Page 5: Preparing The Unit
WINCO take care of the freight claim. If you sign for the unit, the transfer of the ownership requires that you file the freight claim... -
Page 6: Automatic Voltage Regulator
AUTOMATIC VOLTAGE REGULATOR These engines produce enough direct current to keep the battery charged under normal operating conditions, but were not intended to be used as a battery charger. WARNING: PERSONAL INJURY Lead acid batteries produce explosive hydrogen gas when charging. Keep sparks, flames, and burning cigarettes away from the battery. -
Page 7: Initial Start Up
INITIAL START UP 1. Check oil level, refill as needed. 2. Turn on the fuel supply. Ref “A”. 3. Engage the choke (“B”) by pulling it out. A warm engine The throttle control on these generators is preset and locked to operate will require less choking than a cold engine. -
Page 8: Connecting The Loads
CONNECTING THE LOADS OPERATING SPEED The engine-generator must be run at the correct speed in order to produce the proper electrical voltage and frequency. APPLYING THE LOADS CAUTION: EQUIPMENT DAMAGE The output voltage should be checked to ensure the generator is Allow the engine to warm up for two or three minutes before applying working properly prior to connecting a load to the generator. -
Page 9: Wiring
ENGINE CARE WIRING ENGINE CARE Plug your tools such as drills, saws, blowers, sump pump, and MAINTENANCE SCHEDULE other items to be powered directly into the generator receptacles. Before plugging in all the tools and cord sets, recheck the rating Maintenance Chart of the generator set. -
Page 10: Troubleshooting
SPARK PLUG C. Remove the oil filter and dispose of it properly. D. Before you install the new oil filter, clean the filter mounting base and coat the seal of the new oil filter will clean engine oil. Replace annually or every 100 above hours of operation. Always E. -
Page 11: Generator Care
GENERATOR CARE B. Receptacles - Quality receptacles have been utilized. If a receptacle should become cracked or otherwise damaged, replace it. Using damaged or cracked receptacles can be both Proper care and maintenance of the generator is necessary to ensure dangerous to the operator and destructive to the equipment. -
Page 12: 36 Month Limited Warranty
WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE. WINCO is liable for the repair or replacement of the product only and is not liable for incidental or consequential damages as permitted by your state. This warranty gives you specific legal rights which may vary from state to state.
Need help?
Do you have a question about the W10000VE/A and is the answer not in the manual?
Questions and answers