Subscribe to Our Youtube Channel
Related Manuals for Winco DP3000/T
Summary of Contents for Winco DP3000/T
- Page 1 DP3000/T GENERATOR INSTALLATION AND OPERATORS MANUAL WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831 www.wincogen.com...
-
Page 2: Table Of Contents
Should you experience a problem please follow the “Troubleshooting Tables” near the end of this manual. The warranty listed in the manual GENERATOR CONNECTIONS describes what you can expect from WINCO should you need service STARTING ELECTRIC MOTORS assistance in the future. -
Page 3: Specifications
NOTE: CAUTION is also used on the unit labels and in this manual to indicate a situation that could result in serious damage or destruction of GENERATOR the equipment and possible personal injury. Model DP3000/T 1. ELECTRIC SHOCK - Surge Watts 3,000 Continuous Watts... -
Page 4: Introduction
GENERATOR CONNECTIONS let WINCO take care of the freight claim. If you sign for the unit, the transfer of the ownership requires that you file the freight claim DP3000/T: Rated at 3,000 starting Watts and 2,500 continuous Watts. -
Page 5: Oil Recommendations
CAUTION: EQUIPMENT DAMAGE have the correct amount of oil. The full oil level mark on the dipstick is depicted in the following image. Do not use unapproved gasolines, such as E15 or E85. Do not mix oil in the gasoline. Use of unapproved fuels will damage the engine components and void the engine warranty. -
Page 6: Starting Hints
STOPPING AND STORING 4. Turn the engine switch to the ON position. To stop the engine in an emergency, simply turn the engine switch to OFF position. Under normal conditions, use the following procedure. 1. Allow the generator to run under no load for at least 2 minute to cool. -
Page 7: Connecting The Loads
CONNECTING THE LOADS This frequency variation has no appreciable effect in the operation of motors, lights, and most appliances. However, electronic equipment and clocks will be affected if correct RPM is not maintained. See Load APPLYING THE LOADS vs. Output chart. Although individual units and models vary slightly, the normal voltage Allow the engine to warm up for two or three minutes before applying and frequency of the engine-generator described in this manual are... -
Page 8: Engine Care
ENGINE CARE WIRING Plug your tools such as drills, saws, blowers, sump pump, and MAINTENANCE SCHEDULE other items to be powered directly into the generator receptacles. Before plugging in all the tools and cord sets, recheck the rating of the generator set. Be sure it can handle the intended load and If major engine service or repair is required, contact an authorized is compatible with the voltage, phase, and current ratings. -
Page 9: Air Filter
Dispose of used motor oil in a manner that is compatible with the a moist rag. Be careful to prevent dirt from entering the air duct environment. Do not throw it in the trash, pour it in the ground, or pour that leads to the carburetor. -
Page 10: Generator Care
GENERATOR CARE TROUBLESHOOTING Problem Possible Causes Proper care and maintenance of the generator is necessary to ensure a Won’t start Low oil level long trouble free life. Fouled spark plug Out of fuel EXERCISING THE GENERATOR Start switch in OFF position Fuel Valve turned off Choke Open The generator should be operated every three to four weeks. -
Page 11: Outline Drawing
OUTLINE DRAWING RECEPTACLE WIRING DIAGRAM HOUR METER OPM-116 REV B... -
Page 12: 36 Month Limited Warranty
WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE. WINCO is liable for the repair or replacement of the product only and is not liable for incidental or consequential damages as permitted by your state. This warranty gives you specific legal rights which may vary from state to state.
Need help?
Do you have a question about the DP3000/T and is the answer not in the manual?
Questions and answers