Installing The Battery Pack; Turning On The Power - HPI Racing Mini Recon Manual

Installing the battery pack

1. You need to insert the battery pack in the
open section for the battery. Use the strap provided
to place on top of the battery and then use the 2
retaining clips to secure the battery.

Turning on the power

Place vehicle on block to prevent wheels from touching the ground
Turn on transmitter first and then turn on receiver.
Turn on the transmitter switch and the LED battery indicator will light up.
If it blinks or does not light up, check the polarities and battery power.
If the battery power is low, replace the batteries with new ones.
Extend the aerial to its full length.
Turn on the receiver. The automatic set-up of the factory set speed control should
have been completed. If you experience any problems with the speed control settings refer to the Electronic Speed
Control Section for correct setup information.
If the front tyres are not pointing straight forward with the transmitter on, adjust the steering trim. Then if needed
make fine adjustments with the steering trim whilst driving the vehicle.
If wheels point left, turn clockwise
2. Once fastened and secured please connect
the battery plug into the speed controller plug
noting correct polarity. Red to red, black to black.
If wheels point right, turn anti
clockwise.
8
If they point straight no
adjustment req.