Lenovo ideacentre 610S Hardware Maintenance Manual page 39

6. Remove the system board shield and the storage drive board shield. See "Replacing the system board
shield and the storage drive board shield" on page 31.
7. Remove the 2.5-inch storage drive as shown.
Figure 18. Removing the 2.5-inch storage drive
8. Install the new 2.5-inch storage drive.
9. Reinstall the storage drive board shield and the system board shield. See "Replacing the system board
shield and the storage drive board shield" on page 31.
10. Reinstall the wireless card. See "Replacing the wireless card" on page 30.
11. Reinstall the power button board. See "Replacing the power button board" on page 30.
12. Reinstall the I/O board shield. See "Replacing the I/O board shield" on page 26.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 47.
Replacing the M.2 solid-state drive
To replace the M.2 solid-state drive, do the following:
1. Remove all media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and all cables that are connected to the computer.
2. Remove the computer covers. See "Removing the computer covers" on page 23.
3. Remove the I/O board shield. See "Replacing the I/O board shield" on page 26.
4. Remove the power button board. See "Replacing the power button board" on page 30.
5. Remove the wireless card. See "Replacing the wireless card" on page 30.
6. Remove the system board shield and the storage drive board shield. See "Replacing the system board
shield and the storage drive board shield" on page 31.
.
Chapter 7 Installing or replacing hardware
33