6. Remove the body cover as shown.
Figure 9. Removing the body cover
Replacing the I/O board shield
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1 .
To replace the I/O board shield, do the following:
1. Remove all media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and all cables that are connected to the computer.
2. Remove the computer covers. See "Removing the computer covers" on page 23.
26
ideacentre 610S Hardware Maintenance Manual