Replacing The I/O Board - Lenovo ideacentre 610S Hardware Maintenance Manual

3. Remove the I/O board shield as shown.
Figure 10. Removing the I/O board shield
4. Install the new I/O board shield.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 47.

Replacing the I/O board

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1 .
To replace the I/O board, do the following:
1. Remove all media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and all cables that are connected to the computer.
2. Remove the computer covers. See "Removing the computer covers" on page 23.
3. Remove the I/O board shield. See "Replacing the I/O board shield" on page 26.
.
Chapter 7 Installing or replacing hardware
27