Table of Contents
Advertisement
Lights
None
Solid Green
Flashing Blue (slow)
Flashing Blue (fast)
Solid Blue
Flashing Red
Solid Red
Place your BryFi in a location where you'd like to enjoy your music.
Align the round connector from the supplied power brick to the jack marked 15VDC IN on the back of your BryFi by keeping the
flat side of the connector facing up before inserting fully.
Plug the supplied power cable into the power brick and then into a nearby wall outlet.
Optional: If you are connecting to a wired network, flip down the door at the bottom front of the BryFi and plug in an Ethernet
cable. Do not connect an Ethernet cable if you'd like to connect your BryFi to a wireless network.
Flip down the door at the bottom front of the BryFi and press the white button. You should see a green LED illuminate.
In approximately 45 seconds you will hear a xylophone start-up sound, followed by a flashing blue LED, indicating that the system is
in hotspot mode and ready to be added to your home WiFi network.
Find the Section in the following pages for your device type
Section 1 – iOS devices
Section 2 – Android Devices
Section 3 – Windows PC
Section 4 – Mac computer
2
Status Lights
Status/Description
BryFi is off
BryFi is on
BryFi is in hotspot mode
BryFi is in hotspot mode and is in WiFi accessory configuration mode
BryFi is connected to local WiFi / wired network
BryFi is out of range of local network / configuration error
BryFi battery needs charging (if equipped)
Connect to Power
Turn On
Connect to WiFi
Advertisement
Table of Contents
