JVC RX-7001PGD Service Manual page 3

Disassembly method
Removing the top cover (See Fig.1)
1. Remove the four screws A attaching the top cover
on both sides of the body.
2. Remove the three screws B on the back of the body.
3. Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1. Disconnect the card wire from connector CN400 on
the main board and CN402 on the power supply
board in the front panel assembly.
2. Cut off the tie band fixing the harness.
3. Disconnect the harness from connector CN202 on
the video board.
4. Remove the three screws C
panel assembly.
5. Remove the five screws D attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.
Removing the rear panel (See Fig.4)
Prior to performing the following procedure, remove
the top cover.
1. Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2. Remove the twenty-eight screws E
each boards to the rear panel on the back of the
body.
3. Remove the three screws F attaching the rear panel
on the back of the body.
(See Fig.2 and 3)
Main board
attaching the front
attaching the
Top cover
A
2
A
2
C
CN400
Tie band
Video board
CN202
Fig.2
D
Fig.3
E
3
E
E
E
3
3
E
3
E
F
Rear panel
Fig.4
RX-7001PGD
B
Fig.1
Front panel assembly
C
Power supply
board
CN402
Front panel assembly
D
5
E
Cord stopper
E
2
E
F
F
E
E
1-3