Advertisement
Key Features
VDSL InTERFaCE
•
8 x
Spring terminal block connectors for VDSL connection
•
8 x
Spring terminal block connectors for telephone/POTS
connection
•
Built-in POTS splitter for each VDSL port
•
Link to VC-201 CPE Bridge
•
Auto-speed function for VDSL2 link (by distance and cable
quality)
ETHERnET InTERFaCE
•
1-Port Gigabit TP/SFP combo interface
•
Auto-MDI/MDI-X detection on Gigabit RJ-45 port
VDSL2 FEaTURES
•
Cost-effect VDSL2 link and central management solution
•
ITU-T G.993.2 VDSL2 standard
•
DMT (Discrete Multi-Tone) line coding for VDSL
•
Up to 100/55Mbps asymmetric data rate
•
Copper wiring distance up to 1km
•
Selectable target data rate and target SNR margin
•
Build-in surge protection against surge damage from high
energy spike
•
Voice and data communication can be shared on the existing
telephone wire simultaneously
LayER 2 FEaTURES
•
Complies with IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX,
IEEE 802.3z 1000Base-SX/LX, IEEE 802.3ab 1000Base-T, IEEE
802.3x flow control, IEEE 802.1Q VLAN and 802.1p priority
queuing
•
8K MAC address table, auto-ageing, 3.6G backbone
•
IEEE 802.3x Full-duplex flow-control and back-pressure in half-
duplex eliminate packets loss
•
High performance of Store and Forward architecture,
broadcast storm control and runt/CRC filtering eliminate
erroneous packets to optimize the network bandwidth
•
IEEE 802.1Q
Tagged based VLAN and Port-Based VLAN
•
IEEE 802.1Q Tagged VLAN, supports tag insertion and removal,
and up to 32 VLAN groups
•
Supports up to 2
Trunk groups, up to maximum 4 ports per
group each trunk
Data Sheet
4
QUaLITy oF SERVICE
•
2 priority queues on all switch ports
•
Supports QoS and bandwidth control (Rate Limit) on each VDSL
and GbE port
•
Traffic class assignment based on IP TOS/DSCP mode, 802.1p
priority tag mode and Port-Based mode
•
Support for strict priority and Weighted Round Robin (WRR)
CoS policies
MULTICaST
•
IGMP Snooping v1 and v2
SECURITy
•
Port mirroring for dedicated port monitoring
•
MAC address based on port security, unknown source of MAC
address will be ignored on a specified port
ManagEMEnT
•
WEB-based management
•
SNMP v1, v2c interface monitor*
•
SNMP Trap* for status alarm of VDSL port link up and link
down
•
48VDC power input for telecom installation (VC-810S48)
•
Reset Button for system reset and Reset to factory default
•
Firmware upgrade by TFTP file transfer protocol through
Ethernet networks
•
Port Description (Double bit column)
•
PLANET Smart Discovery Utility for deploy management
•
EMI standards comply with FCC, CE class A
* Future Released
VC-810S
VC-810S48
Advertisement
