Step 13: Connecting The Drain Hose - Insignia NS-DWH2BS8 Installation Manual

Step 13: Connecting the drain hose

IMPORTANT:
1 Cut on the marked line as required for your installation. The drain hose's molded end will fit 5/8", 3/4" or 1"
diameter connections on the air gap, waste tee, or garbage disposal.
2 If a longer drain hose is required, you can add up to 42" (1.1 m) of length, for a total of 10 ft. (3.01 m) to the
factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends.
Secure the connection with screw-type hose clamps.
IMPORTANT:
3 Secure the drain hose to the air gap, waste tee, or garbage disposal with a screw-type clamp, using the
appropriate method below. See "Drain preparation" on page 6, if you do not know which method to to use.
Method 1 - Air gap to a waste tee or garbage disposal.
Follow all local codes and ordinances.
Cutting lines
For proper drain operation, the total drain hose length must not exceed 10 ft. (3.01 m).
Screw-type hose clamp
Airgap
Waste tee installation
www.insigniaproducts.com
IMPORTANT: Do not cut
corrugated portion of hose
Screw-type hose clamp
Coupler
Garbage disposal installation
Top Control Dishwasher
Airgap
19