Arm/Disarm Motors 1; Basic Flight - UBSAN X4 STAR FPV User Manual

5.4 ARM/ DISARM THE MOTORS
Arm the motors
Method : Pull both sticks to the lower outer corner as shown
on the picture to arm the motors. Release both sticks
after the motors are armed.
If the motors can not be armed after binding, please make sure:
1. Compass calibration is completed
2. The value of Fly When No GPS is "YES"
3. GPS switch and RTH switch is OFF.
Disarm the motors
Method : Pull both sticks to the lower outer corner again to arm the motors, and release both sticks
after the motors are disarmed.
Do not stop the motors during the flight to avoid crashing.
Push the sticks lightly. Release the sticks after the motors are armed or disarmed.

5.5 Basic Flight

The operations of the controller are based on Mode 2.
The left stick controls the altitude and rudder of quadcopter, and the right stick controls
its forward, backward, left and right flight.
Transmitter (Mode 2)
©
2016 Hubsan
11
哈博森科技 版权所有
X4
UP
Down
Right rotation
Left rotation
Remarks
The throttle stick controls the ascent and
descent .
Push up the stick and the X4 will ascend.
Pull down the stick and the X4 will descend.
When the stick is in the center, the X4 will hover
and hold its alititude automatically .
Move the throttle stick above the center position
to take off. (Move the stick gradually to prevent
the X4 from ascending too quickly.)
The Rudder stick controls the rotate direction
Push the stick to the left and the X4 will rotate
counter-clockwise
Push the stick to the right and the X4 will rotate
clockwise.
When the stick is in the center,the X4 will keep
the current direction and not rotate.
Pushing harder will cause the X4 to rotate
faster in the corresponding directions.