SIMATIC Automation Tool device support
7.1
Unrecognized firmware versions and devices
The device support tables show the correspondence between SIMATIC Automation Tool
V2.1, SIMATIC device model, possible firmware versions, and supported tool operations.
If you connect an unrecognized SIMATIC device on your network, then there are two
possibilities.
● The SIMATIC Automation Tool V2.1 recognizes the device article number, but the
firmware version is newer than latest supported firmware version. In this case, the device
is loaded in the Device table, but the supported tool operations are restricted to those that
were possible with the latest supported firmware version.
● The SIMATIC Automation Tool V2.1 does not recognize the article number. In this case,
the device is not supported, no entry is made in the Device table, and no tool operations
are possible.
7.2
S7-1200 CPU support
S7-1200 operation support and firmware version
A check mark (✓) means that the operation is supported. Standard CPUs have only the
firmware version number in the column header. Fail-Safe CPUs have "Fail-Safe" in the
column header.
S7-1200
Scan for devices
Flash LED
Set IP address
Set PROFINET name
Set time to PG/PC time
Program update
Firmware update
Put CPU in RUN/STOP
Reset CPU memory
Read Diagnostic buffer
Upload service data
Backup and Restore
Reset to factory defaults
SIMATIC Automation Tool V2.1 user guide
Manual, V2.1.1 07/2016, A5E33042676-AC
V1.x
V2.x
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
V3.x
V4.0
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
7
V4.1
Fail-Safe
V4.1
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
121