Removal steps of the MXM board
Step
Screw (quantity)
1
M2 × L3 mm, flat-head, nylon-coated (2)
1210 System board assembly
Read "Before servicing the computer" on page 70 first.
Important notices for handling the system board
When handling the system board, read the following:
• The system board has an accelerometer, which can be broken when several thousands of G-forces
are applied.
Note: Dropping a system board from a height of as little as six inches so that it falls flat on a hard bench
can subject the accelerometer to as much as 6000 G's of shock.
• Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or
composite.
• Avoid rough handling of any kind.
• At every point in the process, be sure not to drop or stack the system board.
• If you put a system board down, be sure to put it only on a padded surface such as an ESD mat or a
corrugated conductive material.
For access, remove this FRU:
•
"1020 Bottom cover" on page 72
•
"1030 HDD" on page 72
•
"1040 M.2 SSD" on page 72
•
"1050 Memory module (under the bottom cover)" on page 74
•
"1060 Wireless WAN card" on page 75
1
1
Color
Silver
.
Chapter 9
Torque
0.181 Nm
(1.85 kgf-cm)
Removing or replacing a FRU
95