Package Contents; Assembly And Installation - MALUX ResistTel MB Operating Instructions Manual

Package contents

The package contains:
ResistTel MB phone
-
Operating manual
-
2 sticky label panels
-
MB sticker
-

Assembly and installation

The device can be installed only on a solid and vertical wall. Loosen the
screws of the cover (2) (see the overview of the device on page 5 to 7)
and take off the top part of the phone (1). When using the optional
accessories: headset or second headset, mount the hook (10) with two
screws (11) on the rear side of the lower part of the phone (In case of
the above accessories, the hook and the screws and also in case of all
optional accessories the cable gland is included in the respective
package). Insert four screws with a head diameter of 10 to 13 cm in the
opening (20) and mount the lower part of the phone (3) on the wall or a
panel.
Insert the phone wire through the cable gland (4) and connect it to the
clamps 13 and 14 (A, B) according to the wiring plan. Only use wires
with an outer diameter of 5 to 9 mm, the IP66 rating of the device cannot
be otherwise guaranteed.
Connecting the secondary sounder (for W conductor)
(optional accessory)
Remove the sealing plug (5) and screw in the M20x1.5 cable gland
completely. Insert the wire of the secondary sounder through the
cable gland and connect it to the clamps 15 and 16 (Bell shunt 1,
Bell shunt) according to the wiring plan. Only use wires with an outer
diameter of 5 to 9 mm, the IP66 rating of the device cannot be
otherwise guaranteed.
Connecting the speaker (optional accessory)
Remove the sealing plug (6) and screw in the M20x1.5 cable gland
completely. Insert the wire of the speaker through the cable gland
and connect it to the clamps 11 and 12 (SPK+, SPK-) according to
the wiring plan. Only use wires with an outer diameter of 5 to 9 mm,
the IP66 rating of the device cannot be otherwise guaranteed.
www.malux.se
9