Monte Carlo Fan Company 5DOR52 Series AC-552 Owner's Manual And Installation Manual page 5

19
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter . If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
2
Loosen one and remove one preassem-
bled screw from mounting bracket. Save
screw. Lift canopy up, aligning its keyhole
slot with the preassembled screw on
mounting bracket and twist clockwise to
lock in place. Re-install the removed
screw and tighten all screws securely.
25
Check the motor for plastic shipping stabiliz er
tabs, and remove them if they are present.
Attach blade assembly to motor by tighten
screws securely.
© 2011 Monte Carlo Fan Company
20
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet bo x.
23
Place floating brackets onto blades aligning
holes in blade with the floating br acket.
26
Loosen the 2 screws with k ey slots and remove
the screw without key slot. Pass plug and
capacitor through hole in plate. Take plate and
place over the 2 screws with k ey slots and
twist to hold in place.
5
21
AC 120 V input
black white
white
black
green ground
green ground
Make wiring connections as shown black wire
from house to black wire from fan. White wire
from house to white wire from fan. Connect all
green ground wires to ground wire from house.
Refer to diagram above.
24
Place blade arms onto the other side of the
blade and aligning holes. Insert screws with
fabric washers through the holes and tighten
securely.
27
Capacitor
Tighten the three screws securely holding the
plate for the switch housing. R emove the dou-
ble sided tape from capacitor and stick capaci-
tor to plate.
4/25/2012